.png)
.png)
Noticias
-
500℃ Circular Heating Mold: High-Temperature Sample Preparation to Empower Material Analysis
Leer másIn material science, polymer R&D, inorganic powder research, and infrared spectroscopy sample preparation experiments, molds are the core components that determine the quality of formed samples. Conventional pressing molds cannot withstand high-temperature working conditions and often suffer from difficult demolding, sample cracking, and uneven heating, which directly impair the accuracy of subsequent test data. Developed […]
-
Another Overseas Milestone: 100-Ton Split-Type Automatic Pellet Press Installed at a New-Material Enterprise in Malaysia
Leer másRecently, a new-material enterprise in Malaysia completed the acceptance and commissioning of the HENCH 100-ton split-type automatic pellet press. As a high-end laboratory pressing instrument for material sample preparation, the equipment has been officially put into operation in an overseas laboratory. This marks the further expansion of HC laboratory sample-preparation instruments into the Southeast Asian […]
-
HENCH IR Desiccator: Precise Humidity Control, Consumable-Free, Long-Term Protection for FTIR Spectrometers
Leer másFTIR spectrometers are widely used in university research, pharmaceutical quality control, chemical analysis and material testing. However, sensitive internal components, including optical lenses and detectors, can be affected by prolonged exposure to humid air. Excessive moisture may cause lens mildew, baseline drift and measurement errors, affecting spectral accuracy and instrument service life. Designed for Thermo […]
-
Isostatic Pressing for Crack-Free and Delamination-Free Pellets
Leer másPellet cracking, delamination, internal porosity, and uneven density can compromise powder compaction experiments. These problems often arise when conventional uniaxial presses apply pressure from a single direction. Friction between the powder and die wall can create density gradients and residual stress inside the compact. These defects may become more obvious during demolding, sintering, or later […]